Similarly to AMD-3, TGM-7 produces dimensionally accurate and stable resin miniatures. With more flexibility and stiffness, this ensures that the 3D prints are precise but less brittle. Combined with a paintable opaque and non-sticky surface, this resin is a perfect choice for minis that can be actively used for tabletop gaming.

TGM-7 resin is available in grey and clear. The grey variant is carefully pigmented to get an ideal colour that expresses the most intricate details of your resin miniatures. Colour is almost fully opaque. Surface is non-sticky and hard (75-85 shore D). After post-cure, the print does not feel sticky or tacky and is pleasant to touch. It does not scratch very easily. It can be primed and painted with most popular paints.

TGM-7 is not resistant to moisture. 3D printed objects with TGM-7 material should not be used for models and parts that will be in constant contact with water, organic solvents or other liquids.

TGM-7 material has a bit higher viscosity than most 3D printing resins. This 3D material should not be left submerged in solvents for extended periods of time. By all means do not leave submerged in IPA or any other liquid for more than 40 minutes. Doing so might ruin your models and affect final properties of polymer material.

If you use Phrozen Wash & Cure Kit, leave the printed object submerged in IPA for approx. 12 minutes. Depending on the results, you can repeat this step again and leave for additional 6 minutes.

If you prefer to clean with ordinary IPA baths, here is our easy 4 steps cleaning procedure:

1. After taking your printed object off the build plate leave it submerged in the IPA bath for 10 minutes.
2. Swirl the IPA bath with our part in it actively for another 1 minute.
3. After swirling, leave it still, but fully submerged for another 10 minutes. At this point it would be wise to change IPA to clean one.
4. Finally, swirl the bath actively again for 1 minute.

Evaluate cleaning results and repeat this procedure only once (if needed).

It is easier to remove supports before post-curing. However, you can also post-cure a print with supports and remove them later. Depending on the model this can help to obtain better geometries if you have such goal. Post-curing time depends on your curing station, and can vary from 5 minutes to 1 hour (until the surface of your 3D print becomes non-sticky). You should post-cure immediately after cleaning and drying. After proper post-curing surface of TGM-7 printed resin miniatures should be completely non-sticky and very hard to scratch.